Stainless steel bar and rod
Round, flat, square and hexagonal stainless bar in 304/304L, 316L, 321, 303 and 904L, hot rolled, cold drawn, peeled or ground, to ASTM A276, A479 and A582.
Bar is specified by diameter, condition and tolerance class, because machinability depends on all three. Cold-drawn and ground bar holds a tight diameter tolerance for automatic screw machines; peeled or turned bar removes surface defects for forging and shaft work; 303 adds sulphur for free machining at some cost in corrosion resistance.
Bar & Rod: sizes and supply condition
| Round bar diameter | Typical trade range 3–500 mm |
|---|---|
| Flat bar | Thickness 3–100 mm × width 10–300 mm |
| Square and hex bar | Quoted per order |
| Length | 3 m / 6 m / cut to length |
| Condition | Hot rolled, annealed, cold drawn, peeled, ground, Q&T on request |
Ranges are typical trade values. The exact size, tolerance and condition are confirmed on the quotation, and the mill certificate states what was actually supplied.
Grades supplied in this form
| Grade | UNS | EN | Typical service |
|---|---|---|---|
| 304 / 304L | S30400 / S30403 | 1.4301 / 1.4307 | General machining and fabrication |
| 316 / 316L | S31600 / S31603 | 1.4401 / 1.4404 | Marine and chemical components |
| 303 | S30300 | 1.4305 | Free-machining parts (not for welding) |
| 321 | S32100 | 1.4541 | Elevated-temperature fasteners |
| 904L | N08904 | 1.4539 | Acid-resistant valve and pump parts |
Standards quoted against
- ASTM A276 / A276M
- ASTM A479
- ASTM A582 (free machining)
- EN 10088-3
- JIS G4303
3 bar & rod specifications
Each page carries the grade, standard, finish and size range for that item, with a mill certificate on every shipment.
Where it is used
- Shafts and spindles
- Fasteners
- Valve and pump components
- Food machinery parts
- Architectural fittings
Bar & Rod FAQ
Which condition should I order for CNC machining?
Cold-drawn or ground bar for tight diameter tolerance and good surface finish on automatic machines; peeled or turned bar where surface defects must be removed but a softer condition is acceptable. State your tolerance and surface requirement on the inquiry.
Is 303 a substitute for 304?
Only for machined parts that will not be welded. The sulphur addition in 303 improves machinability but reduces weldability and corrosion resistance, so it is not a general substitute for 304.
Can you supply cut lengths?
Yes, cut to length with the tolerance stated on the quotation. Give the finished part length and the allowance you need for machining.
Quote bar & rod against your specification
Send grade, size, quantity and any certificate requirement. Reply within 24 hours, Monday to Saturday. Free samples available.
Other product forms
Stainless is supplied in six forms; grades are shared across them.