The four numbers
A coil order that specifies only "304, 0.5 mm" leaves three decisions to the supplier. Width decides whether the coil fits the line; temper decides whether it forms or cracks; coil weight decides whether the crane and uncoiler can handle it. Each is a separate line on a proper purchase order.
Temper and what it controls
Cold-rolled stainless is supplied in tempers defined by the amount of cold reduction and the subsequent anneal. Annealed material is soft and highly formable; quarter-hard, half-hard and full-hard material is progressively stronger and less ductile. The designation used in European practice is the EN 10088-2 temper, while American practice refers to annealed, 1/4 hard, 1/2 hard and full hard.
The consequence is that "304, 0.5 mm" at two different tempers is effectively two different materials for a press line. If the part is deep drawn, specify annealed; if it needs stiffness in service, specify the harder temper and confirm the bend radius it allows.
Slitting and burr
Slit strip is produced by running a wide coil through rotary knives. The cut edge carries a burr, and burr height is the variable that separates a good slit coil from a marginal one. Excessive burr damages tooling, interferes with stacking, and in welded tube it can disrupt the weld pool.
A practical specification states a maximum burr height and the measurement method, or simply requires the edge to be deburred or rounded where the strip will be handled manually. The tolerance on slit width is equally important for progressive dies: a strip a few tenths of a millimetre narrow will not locate reliably.
Eye-to-sky or eye-to-wall
Eye-to-sky stands the coil on its edge with the bore vertical, which suits most uncoilers and slitting lines. Eye-to-wall lays it with the bore horizontal, which suits certain cut-to-length lines and reduces the height needed in a container.
The choice is not cosmetic: it changes the packing, the lifting arrangement and the container loading pattern. State it on the order, and state the inner diameter your mandrel needs.
Coil for welded tube
Tube producers care about different things from sheet users. Slit width tolerance and edge quality drive the weld; thickness consistency drives wall uniformity; and temper affects the forming rolls. For tube-grade strip, the edge condition and width tolerance are usually more important than flatness.
It is also worth confirming whether the strip is supplied with interleaving or oiled, because surface contamination shows up as weld porosity rather than as a surface defect.
What to put on the order
- Grade, standard and temper, for example "316L to ASTM A240, annealed".
- Thickness with tolerance, and slit width with tolerance.
- Coil inner diameter, maximum coil weight, and orientation (eye-to-sky or eye-to-wall).
- Edge condition and maximum burr height.
- Surface: 2B or BA, oiled or dry, interleaved or not.
- Mill certificate to EN 10204 3.1, with heat number marked on the coil tag.