What a profile actually is
Standard sections — channels, angles, tees — follow published dimension tables, so a buyer can order "channel 100 × 50 × 5" and get a defined shape. A custom profile has no such table: it exists only as a drawing, and every property of the part is defined by what that drawing says.
That is why profile enquiries fail more often than any other product enquiry. The supplier cannot infer what is not drawn, and a cautious supplier will either decline or quote a range wide enough to be meaningless.
What the drawing must contain
- Every dimension of the cross-section, with a tolerance on each — including radii and corner treatments.
- The grade and the standard it is supplied against, or the mechanical property required.
- Length, and the tolerance on length; whether ends are cut square, deburred or mitred.
- Straightness and twist limits, expressed as a value over a stated length.
- Which faces are visible, and the finish required on those faces only.
- Any secondary operation: punching, bending, welding, or assembly.
Tooling and lead time
A non-standard section requires rolls or dies. That tooling is a one-off cost and a one-off lead time, and it sits before the first production part — not alongside it. For small quantities, the tooling can dominate the piece price, which is why the same profile quoted at 500 m and at 5,000 m can look like two different products.
Where the quantity is small, an alternative is to fabricate the section from sheet or plate by bending and welding. That avoids tooling but adds a weld and a finishing operation, and it should be quoted as the distinct option it is.
Tolerance and straightness
Cross-section tolerance and straightness are independent. A profile can be dimensionally perfect and still unusable because it twists over its length, and twist is the defect that most often appears after the part is installed rather than on arrival.
State straightness as a measurable limit — for example, a maximum deviation over a stated length — and state how it will be checked if the part is critical.
Finish on visible faces
Polishing is priced by area and by access. Specifying "polished" without saying which faces leads either to an over-priced quotation or to a part polished where it cannot be seen and left rough where it can. Name the visible faces and the finish designation, and state whether the grain direction matters.
What to send
- The section drawing in DWG, DXF or PDF — a dimensioned sketch is acceptable only if every dimension carries a tolerance.
- Grade and standard, or the mechanical property required.
- Length, quantity, and whether the order is a trial or a running requirement.
- Straightness limit and the inspection method.
- Visible faces and finish; grain direction if polished.
- Packing and marking requirements, especially for long sections.