Sheet versus plate
The dividing line is the mill route, not a single number. Sheet is cold rolled, which gives tight thickness tolerance, good flatness and a smooth surface. Plate is hot rolled, supplied with mill scale as No.1, and is normally thicker — but the exact boundary varies by mill and by width.
What matters for the buyer is that the two routes carry different tolerances and different surface defaults. A drawing that specifies "3 mm stainless, 2B finish" is asking for cold-rolled sheet; the same thickness as hot-rolled plate arrives as No.1 and cannot be substituted without a finish change.
Thickness and tolerance
Thickness is always nominal, and the permitted deviation is defined by the product standard — ASTM A480 for flat-rolled stainless, EN 10088-2 in European practice. Narrow strip and wide sheet do not share the same tolerance table, and the tolerance widens as width and thickness increase.
This is commercially important: two quotations for "3 mm 304 sheet" can be for materially different amounts of steel, because one may sit at the bottom of the permitted range. Where weight or pressure matters, specify the tolerance class explicitly rather than accepting the mill default.
Surface finish
| Finish | Process | Practical effect |
|---|---|---|
| No.1 | Hot rolled, annealed, descaled | Dull, rough; for further processing or hidden work |
| 2B | Cold rolled, annealed, pickled, skin-passed | Smooth grey; the default for forming and welding |
| BA | Bright annealed in controlled atmosphere | Reflective, smoother; cleanability without polishing |
| No.4 | Mechanical polish, coarse abrasive | Uniform satin with short grain; architectural default |
| Hairline | Fine directional polish | Continuous lines; grain direction becomes visible |
| 8K | Mirror polish and buff | Reflective; shows every wave in the substrate |
Two practical points. Polished finishes are directional: adjacent panels finished in different directions will not match under raking light. And a mirror finish does not hide flatness defects — it amplifies them, so 8K on thin sheet requires a flatness specification as well.
Flatness and residual stress
Flatness is specified separately from thickness, and it is where most complaints originate. Cold-rolled sheet carries residual stress from rolling and levelling; when a part is cut from it, the stress redistributes and the piece can bow. The sheet was flat; the part is not.
Mitigations are practical rather than metallurgical: specify a levelled or tension-levelled product for laser-cut panels, leave generous margins around the cut part, or stress-relieve before final machining where dimensional stability is critical.
Cutting and forming
Laser cutting gives a clean, narrow kerf with minimal heat input and is the default for sheet. Plasma cuts faster on thick plate but leaves a nitride-contaminated, heat-affected edge that must be ground back before welding in corrosive service. Waterjet avoids thermal effects entirely and is used where the edge will be welded without further preparation.
Forming behaviour is driven by the grade and its nickel content: 304 and 316L draw and bend well, while free-machining grades such as 303 crack in bending and should not be specified for formed parts.
What to put on the order
- Grade, product standard and finish designation, for example "304 to ASTM A240, 2B".
- Thickness with tolerance class; width and length, cut to size or mill size.
- Flatness requirement where the part is laser-cut or visible.
- Which face is finished, and the grain direction for No.4 or hairline work.
- Protective film, and whether it must be laser-safe or UV-resistant if the sheet is stored outdoors.
- Mill certificate to EN 10204 3.1, with heat number matching the marking on the sheet.